It's been pretty underwhelming. My use case was a crowned pulley with 1mm tooth pitch (GT2) which is an unusual enough thing that I could not find one online.
The LLM kept going in circles between two incorrect solutions, then just repeating the same broken solution while describing it as different. I ended up manually writing the code, which was a nice brain-stretch given that I'm an absolute noob at OpenSCAD.
The LLM kept going in circles between two incorrect solutions, then just repeating the same broken solution while describing it as different. I ended up manually writing the code, which was a nice brain-stretch given that I'm an absolute noob at OpenSCAD.